Re: Perdition1.18 problem with LDAP query

Hi,

does /usr/local/var/run/ exist?
If not could you run mkdir /usr/local/var/run/ ?


On Mon, May 31, 2010 at 01:29:35PM +0800, cktan wrote:
> Hi,
> 
> Try redo back it was installed without error this time. However,
> error below appear when I start perdition manual as suggested before
> and the service just can't start. Any help?
> 
> May 31 13:26:37 mail2 perdition[11925]: version=1.18, add_domain="",
> authenticate_in=off, authenticate_timeout=1800, bind_address="",
> capability="UIDL  USER", client_server_specification=off,
> config_file="/usr/local/etc/perdition/perdition.conf",
> connection_limit=0, connection_logging=off, connect_relog=300,
> debug=off, domain_delimiter="@", explicit_domain="", group="nobody",
> inetd_mode=off, listen_port="110", log_facility="mail",
> log_passwd="never", login_disabled=off, lower_case="",
> map_library="/usr/local/lib/libperditiondb_gdbm.so.0", map_library_opt="ldap://ldap.abc.com:389/dc=.?uid,mailHost?sub?(mail=%45s)?!BINDNAME=cn=xxx%2cdc=.,X-BINDPW=yyy",
> no_bind_banner=off, no_daemon=off, no_lookup=off, nodename="mail2",
> ok_line="You are so in", outgoing_port="110", outgoing_server="",
> pid_file="/usr/local/var/run/perdition.pop3/perdition.pop3.pid",
> protocol="POP3", server_resp_line=off, strip_domain="",
> timeout=1800, username="nobody", username_from_database=off,
> query_key="", quiet=off, ssl_mode=""
> *May 31 13:26:37 mail2 perdition[11925]: Could not write pid file*
> *May 31 13:26:37 mail2 perdition[11925]: Exiting on signal 1*
> 
> Regards
> 
> 
> cktan wrote:
> >Hi,
> >
> >Thank for your assistance and I tried to patched in and make
> >install, the error below show at the end. :-(
> >
> > /bin/sh ../../../libtool   --mode=install /usr/bin/install -c
> >libperditiondb_daemon.la '/usr/lib'
> >libtool: install: error: cannot install `libperditiondb_daemon.la'
> >to a directory not ending in /usr/local/lib
> >make[5]: *** [install-libLTLIBRARIES] Error 1
> >make[5]: Leaving directory `/root/perdition-1.18/perdition/db/daemon'
> >make[4]: *** [install-am] Error 2
> >make[4]: Leaving directory `/root/perdition-1.18/perdition/db/daemon'
> >make[3]: *** [install-recursive] Error 1
> >make[3]: Leaving directory `/root/perdition-1.18/perdition/db/daemon'
> >make[2]: *** [install-recursive] Error 1
> >make[2]: Leaving directory `/root/perdition-1.18/perdition/db'
> >make[1]: *** [install-recursive] Error 1
> >make[1]: Leaving directory `/root/perdition-1.18/perdition'
> >make: *** [install-recursive] Error 1
> >
> >/Hi,
> >
> >I believe that the problem exists in perdition1.18 as well
> >as rc1, rc2, rc3, ... Basically it was introduced between 1.17 and
> >1.18 and the fix currently hasn't been included in a released version.
> >
> >The patch command can be used to apply this change to perdition1.18.
> >
> >e.g.
> >wget -O LDAP-support-schema-misc-mailHost.patch \
> >	http://hg.vergenet.net/perdition/perdition/raw-rev/28264fe9e31b
> >wget http://www.vergenet.net/linux/perdition/download/1.18/perdition-1.18.tar.bz2
> >tar -jxf perdition-1.18.tar.bz2
> >cd perdition-1.18
> >patch -p1 < ../LDAP-support-schema-misc-mailHost.patch/
> >
> >Regards
> >
> >cktan wrote:
> >>Dear Simon,
> >>
> >>I suppose this problem was noticed on perdition1.18rc1 and it
> >>was resolved for the rc2, rc3 and so on? And how should I patch
> >>it in order to work? Sorry because I'm not familiar with
> >>patching and hope to have some assistance from you.
> >>
> >>
> >>Sorry for not noticing this the first time around but
> >>I think that you are seeing the problem that is resolved by the following
> >>patch:
> >>
> >>http://hg.vergenet.net/perdition/perdition/rev/28264fe9e31b
> >>Regards
> >>
> >>cktan wrote:
> >>>Hi,
> >>>
> >>>I've tried that and it was started without any error but we
> >>>can't login with with the maillog error as below:
> >>>
> >>>
> >>>May 26 15:40:17 mail2 perdition[462]: version=1.18,
> >>>add_domain="", authenticate_in=off, authenticate_timeout=1800,
> >>>bind_address="", capability="UIDL  USER",
> >>>client_server_specification=off,
> >>>config_file="/etc/perdition/perdition.conf",
> >>>connection_limit=0, connection_logging=off, connect_relog=300,
> >>>debug=off, domain_delimiter="@", explicit_domain="",
> >>>group="nobody", inetd_mode=off, listen_port="110",
> >>>log_facility="mail", log_passwd="never", login_disabled=off,
> >>>lower_case="",
> >>>map_library="/usr/lib/libperditiondb_gdbm.so.0", map_library_opt="ldap://ldap.abc.com:389/dc=.?uid,mailHost?sub?(mail=%45s)?!BINDNAME=cn=xxx%2cdc=.,X-BINDPW=yyy",
> >>>no_bind_banner=off, no_daemon=off, no_lookup=off,
> >>>nodename="mail2", ok_line="You are so in",
> >>>outgoing_port="110", outgoing_server="",
> >>>pid_file="/var/run/perdition.pop3/perdition.pop3.pid",
> >>>protocol="POP3", server_resp_line=off, strip_domain="",
> >>>timeout=1800, username="nobody", username_from_database=off,
> >>>query_key="", quiet=off, ssl_mode="", ssl_ca_file="",
> >>>ssl_ca_pat
> >>>
> >>>
> >>>Auth user="[email protected]" passwd="XXXXXX" server="(null)"
> >>>port="110" status="failed: Could not determine server"
> >>>
> >>>Regards
> >>>
> >>>/Hi,
> >>>
> >>>If you are executing perdition on the command line,
> >>>then you need to either use quotes or escape sequences
> >>>as the ldap query string contains characters that
> >>>have special meaning in the shell and I think
> >>>that is why you are seeing this problem.
> >>>
> >>>Could you try the following?
> >>>
> >>>/usr/sbin/perdition.pop3 -m 'ldap://ldap.abc.com:389/dc=.?uid,mailHost?sub?(mail=%45s <ldap://ldap.abc.com:389/dc=.?uid,mailHost?sub?%28mail=%45s>)?!BINDNAME=cn=xxx%2cdc=.,X-BINDPW=yyy'
> >>>/
> >>>
> >>>cktan wrote:
> >>>>Dear all perdition users and experts,
> >>>>
> >>>>I used to have perdition-1.17 work for my mail servers to
> >>>>query for LDAP for mailHost for POP3 and IMAP proxy and
> >>>>normally I will just add a flag in /etc/sysconfig/perdition
> >>>>for POP3 and IMAP and everything will just working fine.
> >>>>Today, I've just setup another mail server (to load balance
> >>>>the mail scanning process and POP/IMAP login) and install
> >>>>with perdition-1.18 (tried also with perdition-1.18rc1), the
> >>>>configuration is the same with my old perdition but I've
> >>>>problem to start the service the error message below. If I
> >>>>remove the (mail=%45s), the service will just start perfect
> >>>>but off course I can't login because ldap will not return
> >>>>anything without the filter. Is there any issue with the new
> >>>>perdition for LDAP query? Looking forward your kind
> >>>>assistance in this matter.
> >>>>
> >>>>Starting perdition services (POP3): /bin/bash: -c: line 0:
> >>>>syntax error near unexpected token `('
> >>>>/bin/bash: -c: line 0: `ulimit -S -c 0 >/dev/null 2>&1 ;
> >>>>/usr/sbin/perdition.pop3 -m ldap://ldap.abc.com:389/dc=.?uid,mailHost?sub?(mail=%45s)?!BINDNAME=cn=xxx%2cdc=.,X-BINDPW=yyy'
> >>>>
> >>>>Regards
> >>>>
> >>>
> >>>-- 
> >>>This message has been scanned for viruses and
> >>>dangerous content by *MailScanner*
> >>><http://www.mailscanner.info/>, and is
> >>>believed to be clean.
> >>>-- 
> >>>This message has been scanned for viruses and
> >>>dangerous content by *MailScanner*
> >>><http://www.mailscanner.info/>, and is
> >>>believed to be clean.
> >>>------------------------------------------------------------------------
> >>>
> >>>______________________________________________
> >>>Perdition-users mailing list
> >>>[email protected]
> >>>http://lists.vergenet.net/listinfo/perdition-users
> >>
> >>-- 
> >>This message has been scanned for viruses and
> >>dangerous content by *MailScanner*
> >><http://www.mailscanner.info/>, and is
> >>believed to be clean.
> >>------------------------------------------------------------------------
> >>
> >>______________________________________________
> >>Perdition-users mailing list
> >>[email protected]
> >>http://lists.vergenet.net/listinfo/perdition-users
> >
> >-- 
> >This message has been scanned for viruses and
> >dangerous content by *MailScanner* <http://www.mailscanner.info/>, and is
> >believed to be clean.
> >------------------------------------------------------------------------
> >
> >______________________________________________
> >Perdition-users mailing list
> >[email protected]
> >http://lists.vergenet.net/listinfo/perdition-users
> 
> -- 
> This message has been scanned for viruses and
> dangerous content by MailScanner, and is
> believed to be clean.
> 

> ______________________________________________
> Perdition-users mailing list
> [email protected]
> http://lists.vergenet.net/listinfo/perdition-users

______________________________________________
Perdition-users mailing list
[email protected]
http://lists.vergenet.net/listinfo/perdition-users