default behavior change with enable-full-header-cmd?

In Pine 4.58 and earlier, with enable-full-header-cmd the H command will
toggle the state of whether-or-not-I-want-to-see-a-header.

In 4.64 (using the port on FreeBSD 7.0), the state remains changed for
only one message.  Each time another message is viewed, the system will
default to showing no header, and you have to hit H again.

This is very annoying if you're trying to compare the headers of many
messages.  Any idea what happened?  The change could have occurred at any
of the versions in between 4.58 and 4.64, but I'm listing the ones I know
about for sure.

Thanks.

Jeffrey Moskot
System Administrator
[email protected]
_______________________________________________
Pine-info mailing list
[email protected]
http://mailman1.u.washington.edu/mailman/listinfo/pine-info