Re: default behavior change with enable-full-header-cmd?

On Thu, 14 Aug 2008, jef moskot wrote:
>In Pine 4.58 and earlier, with enable-full-header-cmd the H command will
>toggle the state of whether-or-not-I-want-to-see-a-header.
>
>In 4.64 (using the port on FreeBSD 7.0), the state remains changed for
>only one message.  Each time another message is viewed, the system will
>default to showing no header, and you have to hit H again.
>
>This is very annoying if you're trying to compare the headers of many
>messages.  Any idea what happened?  The change could have occurred at any
>of the versions in between 4.58 and 4.64, but I'm listing the ones I know
>about for sure.

this was done on purpose.. Enable this pref to get the way you want:

      [ ]  Suppress Full Header Auto Reset                                      
_______________________________________________
Pine-info mailing list
[email protected]
http://mailman1.u.washington.edu/mailman/listinfo/pine-info