Add/Remove AV from Qmail-Scanner

Hi,

I presently use Qmail-Scanner 1.25 with ClamAV successfully. Now, I want to add another AV into my
present setup and integrate it with Qmail-Scanner. What steps should I follow to do the same.
Also, if I want to remove any particular AV after some time, what steps should I follow to remove
it's integration with Qmail-Scanner.

I am confused as I read installation note from Qmail scanner website and understood that "All AVs
must be pre-installed before installing Qmail Scanner". But I have already working server and want
to install another AV. Also, I may be required to remove ClamAV after successful deployment of new
AV.

Thanks & Regards,
Nimesh Pancholi


      ____________________________________________________________________________________
Be a better friend, newshound, and 
know-it-all with Yahoo! Mobile.  Try it now.  http://mobile.yahoo.com/;_ylt=Ahu06i62sR8HDtDypao8Wcj9tAcJ

-------------------------------------------------------------------------
This SF.net email is sponsored by: Microsoft
Defy all challenges. Microsoft(R) Visual Studio 2008.
http://clk.atdmt.com/MRT/go/vse0120000070mrt/direct/01/