Re: Message-ID being stripped from header?

On Thu, 19 Jun 2008 20:26:01 +0900, Salvatore Toribio <[email protected]>  
wrote:

> Well, you have give me a hint.. I was using qs-2.02st, SA-3.2.4 and I  
> haven't seen the issue but I didn't pay atention to it before the  
> release of 2.04.
[clip]
> Maybe you can install 2.02st and enabled 'sa_alt'

I reverted back to qs-2.02 a few days ago, and so far all mails are
coming in with the Message-ID in the header intact.  So the problem is
indeed with qmail-scanner, and not SpamAssassin.

I haven't been using the st patches at all, with either 2.04 or 2.02,
so the problem is with the original code.

I did a diff between the generated qs2.02 and qs2.04, and most of the
changes involved the Clam scanner.  I've never been very good with perl,
so it's a bit difficult for me to understand what's going on.

I will try a step up to 2.03 over the next few days and see if I can
isolate exactly where the problem code is.

-- 
- breakpoint / brainstorm

-------------------------------------------------------------------------
Check out the new SourceForge.net Marketplace.
It's the best place to buy or sell services for
just about anything Open Source.
http://sourceforge.net/services/buy/index.php