Re: Unable to obtain socket and address

Hi and thanks for your support, I am sure that I have used:

#./configure --enable-standalone --without-pam

..and I am sure that I have only qpopper installation, however yesterday I 
have solved my problem (as say you as) in this mode:

#./configure --enable-standalone --without-pam
#make clean
#make && make install

Thanks again.

------
Salvatore.

----- Original Message ----- 
From: "Martin Kellermann" <[email protected]>
To: "Subscribers of Qpopper" <[email protected]>
Sent: Tuesday, July 03, 2007 2:43 PM
Subject: Re: Unable to obtain socket and address


> this indicates that you try to run a version that is NOT compiled
> with standalone mode enabled.
> 
> maybe you have more than one version of popper installed!?
> 
> try "cd / && find . -name popper"
> 
> if there really is one single executable, recompile it:
> 
> try doing with a 'make realclean' first....
> 
> 
> MK
> 
> At 13:40 02.07.2007, you wrote:
>>Hi, I have a problem with qpopper 4.0.9 on Fedora Core 6, when:
>>
>>/etc/rc.d/init.d/popper start
>>Jul  2 13:18:33 localhost popper[2621]: Unable to obtain socket and 
>>address of client: Socket operation on non-socket (88)
>>
>>..I have used parameter:
>>
>>#./configure --enable-standalone --without pam
>>
>>Thanks.
>>
>>------
>>Salvatore.
>