Re: Tru64 and C2

At 03:47 PM 12/2/2007 -0800, Randall Gellens wrote:
>At 4:10 PM -0600 12/2/07, Vic Summerour wrote:
>
>>  I have used qpopper with Tru64, Digital Unix, OSF/1 for years. 
>> Sometime in the not so distant past but I can't remember when or 
>> the details of why, I have had to configure with the following:
>>
>>  ./configure --enable-specialauth --without-pam
>
>Was --enable-specialauth needed?  If you left it off, what happened?

With ./configure only, the following occurs:

./configure
  .
  .
  .
checking for pam_authenticate in -lpam... no
Can't use PAM: can't find libpam


With ./configure --without-pam, it will configure and compile 
correctly.  Attempts to retrieve pop mail results in an invalid 
password message:

With ./configure --enable-specialauth --without-pam, it will 
configure correctly, compile, and work.




>>  Currently with Tru64 V5.1A with PK6, I have successfully compiled 
>> and run 4.1a4 with the following compiler:
>>
>>  alpha> cc -V
>>  Compaq C V6.4-014 on Compaq Tru64 UNIX V5.1A (Rev. 1885)
>>  Compiler Driver V6.4-215 (sys) cc Driver
>>
>>
>>  Unfortunately, 4.1a5 will not successfully compile based on the 
>> same configure.  It stop with the error:
>>
>>  cc -c -I.. -I.. -I. \
>>                  -I../mmangle -I../common  \
>>                  -g -DHAVE_CONFIG_H  -DOSF1 -DUNIX main.c -o main.o
>>  cc: Error: main.c, line 150: Missing type specifier or type 
>> qualifier. (missingtype)
>>          socklen_t ai_addrlen;
>>  --------^
>>  make[1]: *** [main.o] Error 1
>>  make[1]: Leaving directory `/dsk1/vic/qpopper/qpopper4.1a5/popper'
>>  make: *** [popper_server] Error 2
>>
>>  This appears to be associated with 4.1a4 to 4.1a5 enhancements 
>> associated with ipv6 support.  Since Tru 5.1A supports ipv6 even 
>> though it is not being used, I tried to configure with:
>>
>>  ./configure --enable-specialauth --without-pam --enable-ipv6
>>
>>  but that made no difference.  By defining INET6 in config.h, 
>> 4.1a5 will successfully compile and run.
>
>Do you know in which header file this is normally defined?  If it is 
>a missing .h on Tru64, fixing ./configure to add it or add it in the 
>right place might be the proper solution.

For Tru64 5.1A PK6, I could not find INET6 defined in any header file 
in any of the obvious include directories.  I also looked briefly 
through the Network Programmer's Guide for mention of it without success.


>--
>Randall Gellens
>Opinions are personal;    facts are suspect;    I speak for myself only
>-------------- Randomly-selected tag: ---------------
>Computers ... are not designed, as we are, for ambiguity.  --Thomas