RE: maildirsmtp to smtp-auth

Thanks,

My own qmail does not deliver messages quick enough, and uses too much
bandwidth. The bandwidth through to the ISP's smtp server is much higher
than bandwidth through to the mail servers.

Also, if a message is being sent to x multiple recipients, my own qmail
will use x times the bandwidth of the message, where as if I send to the
ISP's SMTP server, it will only send the message once, and use the ISP's
bandwidth for multiple recips.

Thanks again for the advice.

Regards,

Brett Cav=E9
=20
Nerds On-Site
Cell: +27 83 380-6554
Phone: +27 11 4855067
Email: [email protected]


-----Original Message-----
From: animesh bansriyar [mailto:[email protected]]=20
Sent: 14 April 2003 11:28 PM
To: [email protected]
Subject: Re: maildirsmtp to smtp-auth



On Mon, 14 Apr 2003, [iso-8859-1] Brett Cav=E9 wrote:

> virtualdomain (pppdir / alias-ppp). Is it possible to get maildirsmtp
to
> authenticate before sending out messages?

I guess this should help.
http://symonds.net/~dushy/serialmail-0.75-smtp-auth.patch

But I will suggest that you use your own qmail for this purpose. This
would save on your bandwidth usage.





Animesh Bansriyar
http://www.neolinuxsolutions.com