Re: Size limiting auto notification for the sender

Hello! Thanks for Your quick response...

> That should be changed to rc.local.s00
> rc.local.s00 is the right place. Take care that you uncomment
> RC_LOCAL_SUBMIT_00 in rc.custom. If you still see nothing put
> "VERBOSE=ON" on the top of rc.local.s00 and look in the log file what
> happens.

I've tried that already, but without success. Here is what I got this time
in an empty letter(I have divertcheck switched to no):
X-From_:foo@bar Wed Feb 19 23:28:29 2003
X-Diagnostic: Not on the accept list   # Of course foo@bar is not on the
From: [email protected] (Smartlist)   # the list. But he wasn't the sender
To: undisclosed-recipients: ;

After that I've got the already well known mail from the list-request to
the fake address (which is only mentioned in the reply-to field in
rc.custom)
Afther this I've tried switching on the divertchek, without pass. That way
got only one letter from the list-request to the fake replay adress.
Then I switched on pass, and got two mails again the second is the same,
but then an emty one with the following lines in the header:
X-From_:foo@bar Wed Feb 19 23:45:05 2003
X-Diagnostic: Diverted & unprocessed
From: [email protected] (SmartList)
To: undisclosed-recipients: ;

I think the list can not figure out the sender from the header of the
mail, and thats why it sets foo@bar.
I have the following lines in rc.local.s00:

:0 wfbh
* !< $size_limit
|formail -rk -I "X-Loop: $listreq" -I "From: $listreq" \
-I "Subject: Sorry, but ... $list max.: $size_limit bytes!" | \
$SENDMAIL -t

I forgot to say, but in the mails which were sent by the list-request to
the fake are no X-Diagnostic lines.
Any suggestions? Now I really want to solve this! :))

Thanks:
Odri Kornel

>
>> My problem with this is the following:
>> If I send a mail bigger than the maximum size, then the owner-listaddr
>> gets a message about the size not the sender. I've set the
>> reply_to="Reply-To: owner-$listaddr" in rc.custom to avoid auto
>> replays.
>
> You won't have these problems if you make rc.local.s00 work.
>
> --
> Werner Reisberger         pgp-public-key available:
>                          http://www.pure.ch/mypubkey.txt
>
> _______________________________________________
> Smartlist mailing list
> [email protected]
> http://MailMan.RWTH-Aachen.DE/mailman/listinfo/smartlist