Re: problem with trainin since upgrade to blamethesegfault

Yup, looked at the '-t' output and it's inside mailtrainer.

Unfortunately, the only way to get -t output from there is a bit too
tricky as all stdout/err output will be catched by syscall in
mailreaver. It's doable, but let's see if the edited mailtrainer.crm I
sent yesterday fares a bit better - it should.



On Thu, Apr 3, 2008 at 2:27 AM, Jason Lewis <[email protected]> wrote:
> Paolo wrote:
>  > yes - perhaps you've already posted it, but could you (re)post it as is
>  > along with mail{reaver,trainer}.crm in use? - better if you can upload to a
>  > wget'able url.
>  >
>  I posted to the list but the file was too big. Here is a wgetable version
>
>  http://flip.dyndns.org/downloads/crmlog.7z
>
>  Jason
>
>
>
>  -------------------------------------------------------------------------
>  Check out the new SourceForge.net Marketplace.
>  It's the best place to buy or sell services for
>  just about anything Open Source.
>  http://ad.doubleclick.net/clk;164216239;13503038;w?http://sf.net/marketplace
>  _______________________________________________
>  Crm114-general mailing list
>  [email protected]
>  https://lists.sourceforge.net/lists/listinfo/crm114-general
>
>



-- 
Met vriendelijke groeten / Best regards,

Ger Hobbelt

--------------------------------------------------
web: http://www.hobbelt.com/
 http://www.hebbut.net/
mail: [email protected]
mobile: +31-6-11 120 978
--------------------------------------------------

-------------------------------------------------------------------------
Check out the new SourceForge.net Marketplace.
It's the best place to buy or sell services for
just about anything Open Source.
http://ad.doubleclick.net/clk;164216239;13503038;w?http://sf.net/marketplace