Re: How and what to do with "User parameters" in filters?

Zygmunt Wereszczynski @ 2005-Jun-12 4:40:18 PM
"How and what to do with "User parameters" in filters?" <mid:[email protected]>

> I tried many times to set and check "additional parameters" in filters, but
> without success. How to use them according to common sense? How to reference
> to the parameter which was set in another filter? Is it possible?

This is what I do:

Every filter for a mailing list I am subscribed to sets a user
parameter called LIST to 1. All of these filter also "Continue
processing with other filters". Below all these filters there is one
called "My List Messages". If a message is from me AND has LIST = 1,
then it is marked as read. Here is that filter:

$$$$ TB! Message Filter $$$$
beginFilter
UID: [DD7E9144.01C501B9.70BC3E00.3FB1FC07]
Name: My\20List\20Messages
Filter: {\0D\0A\20`0`0`c45207-Ij6MdEStJ8hWk0Htik3J/[email protected]\0D\0A0`27`LIST`0`1\0D\0A}
MarkRead
IsActive
Ignore
endFilter

-- 
Chris
Quoting when replying to this message is good for your karma.

Using The Bat! v3.5 on Windows XP 5.1 Build 2600 Service Pack 2.
Accessing a POP3 mailbox.

Today's Oxymoron: Pretty ugly