Re: The sigdash

Hello Ian,

On Sat, 13 Aug 2022 14:58:38 +1000 GMT (13/08/2022, 11:58 +0700 GMT),
Ian A. White wrote:


> When replying with quoting it is not an issue as in this reply, as there can only be a sigdash on the line. Anything else and it is just a normal line of text.

> My problem is that I have some message threads for customers and that means there are 20 signatures with high def graphics that have been quoted. This then limits quoting as the message is now too big and gets rejected. This results in a fresh thread being started, and that causes other issues.

What I do in this case is delete the attachments.

> I do not know if there is a solution. My client uses Outlook and that causes a lot of problems because it does not necessarily show the threading. Outlook also does not recognise a sigdash. At one point I tried using Outlook, but it resulted in so many issues so went back to The Bat! for them. When Microsoft were contacted, it was a case of "Next question". As far as they were concerned they could do whatever they wanted. They even include the actual attachments with each reply, so a job with 7 revisions would see  a huge number of inclusions as the first message has the file, the next reply has the first included plus the rev 1, the next has all these included plus rev 2, and so on.

Ranting against Outllok in this group is praying to the choire! :-)

--


Cheers,
Thomas.

Message reply created with The Bat! Version 10.1.0.2 (64-bit)
under Windows 10.0 Build 19043


________________________________________________
Current version is 9.1.18 | 'Using TBUDL' information:
http://www.silverstones.com/thebat/TBUDLInfo.html