Re: Amavis and OpenDMARC

>>>So Amavis is setup as an smtpd_milter as well?

>>No, Amavis is setup as a content_filter (content_filter = amavis:[127.0.0.1]:10021)

On 11.11.23 11:34, Damian wrote:
>You can't do that. OpenDMARC needs to see Authentication-Results for DKIM.

to be more precise: OpenDMARC running as milter only sees output from 
milters applied before it.

Milter is run pre-queue and content_filter is run after queue, so opendmarc 
does not see that amavis produced, because it was added later.

If you used amavisd-milter at SMTP port, opendmarc could see its output.

I run amavisd-milter at SMTP port, so it can reject spam/viruses immediately 
and amavis as content-filter by default (local and trusted submission).


-- 
Matus UHLAR - fantomas, [email protected] ; http://www.fantomas.sk/
Warning: I wish NOT to receive e-mail advertising to this address.
Varovanie: na tuto adresu chcem NEDOSTAVAT akukolvek reklamnu postu.
Eagles may soar, but weasels don't get sucked into jet engines.