Re: maia not authenticating

I know Josh Small has mentioned on this list that internal authentication is the most supported method to authenticate maia users in the 1.0.4 branch. I think they might have even said that other forms of authentication could be broken or not very well tested. I don't know if that is still the case, but it sounds like it is possible.

Thanks,
-Larry


________________________________________________
Lawrence R. Mulder / RHCE, VTSP, SEC+
Vice President, InformAbility, Inc.
[email protected]
http://www.informability.com/about
http://www.facebook.com/InformAbility
Ph: 630-532-5941
Fx: 630-532-5955
________________________________________________
  Original Message
From: Dave Overton
Sent: Monday, May 11, 2015 5:17 PM
To: [email protected]
Reply To: [email protected]
Subject: Re: [Maia-users] maia not authenticating


Obvious answer, enable POP3?

IIRC, There is no reason not to, IMAP and POP3 use the same everything (authentication, data storage, etc) so just turn it on and fix your problem.

Dave



> -----Original Message-----
> From: Maia-users [mailto:[email protected]] On Behalf
> Of Bob
> Sent: Monday, May 11, 2015 2:19 PM
> To: [email protected]
> Subject: [Maia-users] maia not authenticating
>
> I set up maia per the PHO instructions. It fails to authenticate any
> address. I noticed that the instructions say to do the auth via pop3. I
> don't support pop3 on my server. I tried "imap" but that failed too.
> This is in the /usr/local/www/maia/config.php file. Any thoughts?
> _______________________________________________
> Maia-users mailing list
> [email protected]
> http://www.renaissoft.com/cgi-bin/mailman/listinfo/maia-users

_______________________________________________
Maia-users mailing list
[email protected]
http://www.renaissoft.com/cgi-bin/mailman/listinfo/maia-users
_______________________________________________
Maia-users mailing list
[email protected]
http://www.renaissoft.com/cgi-bin/mailman/listinfo/maia-users