Re: bypassing the acl control

Hello Barriere.

I had the same problem yesterday, and studiet the source code.
The auth is in cgi.c which I modified.

I can attach a modified .tar.gz which is without auth if you whish, please
email me in person for this.

You could use 'diff' with the vanilla source against my modified source to 
make sure I haven't done anything nasty in it.

Cheers,
Martin

On Tue, 25 Jan 2005, Barriere Benoit wrote:

> Hi everyone, 
> 
>  
> 
> I would like to bypass the acl control in the cgi vqadmin. 
> 
> Basically, I have a project to create/modify/delete a user directly by url since a remote web site that is working in ASP.NET. 
> 
> The Vqadmin cgi is good for this task because it's very fast and easy to parameter in the URL. But I need to bypass the acl and htaccess athentification.
> 
> I know to desactivate the Htaccess but the vqadmin acl no....may be in code bu where ? I am not a programmer...
> 
>  
> 
>  
> 
> Any ideas ?
> 
>  
> 
> Thx a lot in advance  
> 
>  
> 
> EUROMED MARSEILLE
> 
> Ecole de Management
> 
> Benoît BARRIERE
> 
> Administrateur Système
> 
> Tél. : + 33 (0)603343381 ou 1014
> 
> Tél. : + 33 (0)491827977 ou 7977
> 
>  
> 
> 

-- 

-------------------------------------------------------------------
[email protected]               LemonLime Internet Development
Drifttekniker & Support           Teknikringen 1B
013  - 21 19 60                   Mjärdevi Science Park
[email protected]                 583 30 Linköping