Re: Correction of the K5-Output-Modification

"[email protected] [k5synth]" <[email protected]> 25 Feb 2016 05:04:38 -0800

Newsgroups	gmane.music.equipment.kawai.k5
Message-ID	<[email protected]>

Hello Jeroen
 

 Here I repeat for you the NEW (correct) modification once again:
 

 The SIMPLEST way to modifiy the output-section of an original K5:
 

 Do NOT replace the original resistors!
But:
Solder eight 22kOhm-Resistors at THE UNDERSIDE of the print PARALLEL to the following original (39kOhm) resistors:
R33, R34, R35, R36, R37, R38, R39, R40.
That`s all.
 

 Best regards
Christian Böckle