Re: K5 OS DIY programming

The V40 is 8086 or 8088 derived, yes? (If I remember from the V20, 
V30.. ;-) (I got sentimental about the Z80 :-) )

Ok, I'll look into OTP devices too. See what I can find - it's been a 
few years since making single board computers, in those days the 
biggest EPROM was a 32k 27256 :-)

Cheers

Adam

--- In [email protected], Antoine Deschênes <antdes45@n...> 
wrote:
> The NEC V40 processor's in there. It's pretty small for a end '80 
CPU.
> 
> g0ory@n... a écrit:
> 
> > Antoine,
> >
> >      Just a side note on the topic, the main controller is by 
NEC, If
> > I'm right. NEC made an awful lot of controllers around the time 
which
> > used the Z80 instruction set, sometimes with a few extra special-
> > purpose instructions - a very underrated processor in it's time, 
and
> > one of the most powerful 8 bit uP's ever.
> >
> > Cheers
> >
> > Adam
> >
> >
> >
> > Yahoo! Groups Sponsor
> > ADVERTISEMENT
> > 
<http://us.ard.yahoo.com/SIG=1297fj4pa/M=306910.5263657.6380312.224846
7/D=grplch/S=1705032144:HM/EXP=1093111549/A=2290377/R=0/SIG=12svasom8/
*http://ad.doubleclick.net/jump/N3390.yahoocom/B1408521.15;sz=300x250;
ord=1093025149238133?> 
> >
> >
> >
> > ------------------------------------------------------------------
------
> > Yahoo! Groups Links
> >
> >     * To visit your group on the web, go to:
> >       http://groups.yahoo.com/group/k5synth/
> >        
> >     * To unsubscribe from this group, send an email to:
> >       [email protected]
> >       <mailto:[email protected]?
subject=Unsubscribe>
> >        
> >     * Your use of Yahoo! Groups is subject to the Yahoo! Terms of
> >       Service <http://docs.yahoo.com/info/terms/>.
> >
> >
> 
> -- 
> antdes45@n...



------------------------ Yahoo! Groups Sponsor --------------------~--> 
Tired of hearing the same songs over and over?
Listen to Internet Radio! Skip songs. Click to listen to LAUNCHcast!
http://us.click.yahoo.com/Ykrq7C/HARHAA/n1hLAA/QnLolB/TM
--------------------------------------------------------------------~->