Re: My new backlight works, I will post pictures

Yes, you can cut it in both the X and the Y direction on one side of 
the strip.  I still have not opened my K5m to see if I can slide a 
new backlight in easily.

didobrain

--- In [email protected], "nelsonj_sce" <nelsonj_sce@y...> 
wrote:
> The nightlaunch site says the strips are 16 inches long.  Did you 
just
> cut it to size?  
> 
> --- In [email protected], "didobrain2000" <Cthane1@a...> 
wrote:
> > Fortunately for K5 users, the new backlight I installed in my 
> > Kurzweil K2000 is designed for 9V battery that is stepped up to 
120V 
> > 400hz!  Meaning it will work for both the K5 and the K2000.  I 
know 
> > this is a K5 users group, but I am so excited about this cheap 
and 
> > easy alternative for my K2000 that I MUST try it on the K5.  (My 
> > Kawai K5000 backlight still works great.)  I am interested to see 
if 
> > you guys think it will be as easy to install on the K5 as it was 
on 
> > my Kurzweil.  The company I purchased this backlight from is 
found at 
> > WWW.nightlaunch.com   I used Pay Pal. Cool...  I will post the 
> > pictures under the picture section.
> > 
> > Didobrain



------------------------ Yahoo! Groups Sponsor --------------------~--> 
Listen to Internet Radio! Access to your favorite Artists!
Click to listen to LAUNCHcast now!
http://us.click.yahoo.com/Zkrq7C/GARHAA/n1hLAA/QnLolB/TM
--------------------------------------------------------------------~->