Re: Re: K5 Repair Issues

Hi Bruce, it's hard to find two identical LCDs. We'd need more 
information about the one you just bought to be able to give out more 
details.

Antoine

BJM a écrit :
> i can empathize with the disappointment of the LCD installation. I 
> picked up a new LCD for my K5M and have been hesitant to install it 
> due to some of those "unknowns" that might come up. If any diagrams, 
> sequential steps, associated problems of the installation were 
> identified for the group and posted that would be great. It seems like 
> the LCD is one of the major problems with this fantastic instrument. I 
> follow along with the group e-mail, and only speak up every now and 
> then and this seemed like a good time. I would really like to have the 
> knowledge to successfully get that LCD installed.
>  
> Bruce
>
> ------------------------------------------------------------------------
> *From:* [email protected] [mailto:[email protected]] *On 
> Behalf Of *Antoine Deschênes
> *Sent:* Tuesday, January 15, 2008 10:38 PM
> *To:* [email protected]
> *Subject:* Re: [k5synth] Re: K5 Repair Issues
>
> Yep, when the power switch wire broke on my K5, I searched for three
> days why my K5 wasn't powering on ;-).
>
> To change the viewing angle of the LCD, you can adjust the CONTRAST
> knob on the back of the synth to make it more comfortable.
>
> The inverter is the "Nichia" branded white box on the power supply
> board you talked about in a previous mail. I'll post a picture (if I
> think about it) and try to tell you how to connect the new inverter (I
> didn't buy a new inverter)
>
> 2008/1/15, ink_blot2001 <ink_blot2001-/[email protected] 
> <mailto:ink_blot2001%40yahoo.com>>:
>
> > I checked around inside. Apparently one of the wires connected to 
> the power switch was
> > disconnected. I re-soldered it. That almost seems as bad as 
> forgetting to plug it in. After
> > turning it on, I noticed two things: the backlight I just installed 
> does not work, and I can't
> > see the text when I look directly down at the display. I don't 
> remember the latter being
> > the case prior to my "repair". I realize that the backlight not 
> working signifies the inverter
> > is bad. What about the text? I now need to look at the display at a 
> slight angle. This isn't
> > an issue, but I don't understand why this is.
> >
> > Also, any information, like where it is located and what it looks 
> like, about the inverter
> > would be appreciated. An image would be wonderful. I checked out the 
> link you posted,
> > but would like more information before I try "fixing" the keyboard 
> anymore.
> >
> > Ivan
> >
> >
> >
> >
> > Yahoo! Groups Links
> >
> >
> >
> >
>
> -- 
> Antoine Deschênes
>
>