Re: Re: PC3K8 Going Out Of Tune

Thanks.  Will do.  Spraying a little was meant to possibly assist in the exercising of the wheel and removal of built up dust.  

From: [email protected] [KurzList] 
Sent: Monday, October 15, 2018 10:12 AM
To: [email protected] 
Subject: Re: [KL] Re: PC3K8 Going Out Of Tune

  

Glad you survived the show. The worry will not subside until you have effectively diagnosed the issue.Suggest now the stress has passed, and with a clear head, go slowly through the 456 diagnostic checks as advised, and see what the machine is actually telling you is wrong.

I could not advise spraying things into a keyboard the hope that a digital problem will go away - how does that even make sense?


Adjusting EntryPan simply overrules the Program's Pan setting.  Are you operating in Mono live?  If you have a dodgy output socket on the mono output you usually use, try the other side - as that could point to an I/O socket issue.  


You should double check the behaviour of the jack sockets by checking AUX L and MAIN L are the same, and AUX R and MAIN R are the same.  There is a toggle in the settings - 
Master > Output > Aux Out Pair Mode : Normal | Mirror Primary Outputs
To compare them, you need to set that appropriately.  You can also check the analogue outputs with the digital outputs - connect an SPDIF cable to the Digital Output, and compare Man, Aux and Digital on your DAWs metering.

But this has nothing to do with the pitch bend issues you originally posted abou so points to a second issue.

Both could however be explained by the loom internally having intermittent connections to the main board.

Hope you get it sorted.