My K2000 isn't happy w/ SCSI2SD v6

"[email protected] [KurzList]" <[email protected]>
Newsgroups gmane.music.equipment.kurzweil
Message-ID <[email protected]> 
Anyone have SCSI2SD v6 working w/ a K2000?  I've found posts of folks using v6 with later Kurzweil models, but haven't yet come across a K2000.
 

 My K2k can see the virtual drives, however any SCSI disk operation on the drive causes the K2k to reboot, then I can no longer access DISK until a power cycle.
 

 K2k is freshly upgraded to v3.84.  SCSI2SD firmware is 6.2.1.  Drive images are 2 GB or less, FAT-16.  No SCSI ID collision.  Tried most all combination of settings in the SCSI2SD configuration.  SCSI2SD is terminated, K2000 is not, tried with and without external SCSI termination. Tried 2 SCSI cables...and pretty much everything else I could think of.
 

 I'm wondering if there's something up w/ my K2000, or if perhaps SCSI2SD v6 just isn't compatible.  This working for anyone else?  Maybe I need to downgrade to v5.
 

 Thanks,
 Jeremy
lmpx.com only provides a reader for public news (NNTP) servers. It is not affiliated with the servers or forums shown here and is not responsible for the content of articles, which is written by their respective authors.