Re: Assigning Midi in Cubas and Kontakt 4 for Z-tar

<[email protected]>
Newsgroups gmane.music.equipment.midi-guitar
Message-ID <[email protected]> 
Lastly you said, create the outputs in the Kontakt GUI to correspond to the output tracks in VST, (that the Ztar is sending on) 

I think that's right on the face of the Kontakt 4 instrument right? If the Z-tar zone is set to channel 2, I think your meaning is set the kontak4 channel to channel 2 also. I've already done that if that's what you mean. 
 

 Next you said, Then route the individual instruments to the separate outputs in the Kontatk GUI by selecting the output on each of the respective instruments.

Where's that? I'm not sure I know how to select outputs. I think you mean in Cubase but I'll look on the Kontakt 4 instrument to see if there's something else besides just setting channels. I'll look into it though and see if I can figure it out.
lmpx.com only provides a reader for public news (NNTP) servers. It is not affiliated with the servers or forums shown here and is not responsible for the content of articles, which is written by their respective authors.