Re: Re: Assigning Midi in Cubas and Kontakt 4 for Z-tar

[email protected]
Newsgroups gmane.music.equipment.midi-guitar
Message-ID <[email protected]> 




On 24 Mar 2014, at 02:38, <[email protected]> wrote:

I did change that field to  "Any and All" but it still didn't produce  any change in the Ztar's functioning. Also, I'm confused about doing that since The ztar manual says that you have to assign the same midi channel to the track it belongs to. "Any and All" sounds like what it says. Channel AND channel 2 will go to whatever tracks are set to ANY and ALL. That wouldn't be what I'm after if that's the case. I'll try what you suggested though with the Cubase commands. The only thing I know to call my software is Cubase 5 but I can look again. 

Best regards,

Greg
lmpx.com only provides a reader for public news (NNTP) servers. It is not affiliated with the servers or forums shown here and is not responsible for the content of articles, which is written by their respective authors.