Re: SB3 occasionally stops / clicks with LMS running on a wired Pi4
rbl <rbl.ariu20-NUepA2SMhDQqspMVqqL2D+4xXEVPTSb/[email protected]>
| Newsgroups | gmane.music.equipment.slimdevices.general |
|---|---|
| Organization | Logitech Squeezebox Forums |
| Message-ID | <[email protected]> |
Paul Webster wrote: > I assume you are using the analogue out from SB3 and connecting to > powered speakers. > > Are there other ways to connect to them just in case it is that final > signal path that is the problem? > > e.g. S/PDIF The Pi4 is connected via the 3.5mm analog out, and the SB3 via the coax digital output. I'd be surprised if that was the problem. I thought there was a buffer setting on the SB3 in LMS but I am struggling to find it! SB3 -> Quad 909 -> Quad Electrostatic speakers, Quad 405 -> TBI subwoofer 3 x SB3s + SB Radio LMS on Raspbian on a Pi4 Rotel RSP1068 surround processor, Quad 707 -> B&W surround ------------------------------------------------------------------------ rbl's Profile: http://forums.slimdevices.com/member.php?userid=4517 View this thread: http://forums.slimdevices.com/showthread.php?t=116857