Re: SB3 connects and then powers off after turning on at wall

The MAC and IP addresses are all different (checked in
LMS->Settings->Information).

I had just hoped there was a setting somewhere but I suspect you are
right, it's probably a hardware thing. Now I think about it the analog
output on this SB3 is broken which is a common problem, fixed by
replacing a capacitor apparently.  I guess these SB3s are pretty long in
the tooth. Probably time to build some Pi based players if I can get the
time as I am not aware of any sensibly priced off the shelf players out
there..



SB3 -> Quad 909 -> Quad Electrostatic speakers, Quad 405 -> TBI
subwoofer
3 x SB3s + SB Radio
LMS on Raspbian on a Pi4
Rotel RSP1068 surround processor, Quad 707 -> B&W surround
------------------------------------------------------------------------
rbl's Profile: http://forums.slimdevices.com/member.php?userid=4517
View this thread: http://forums.slimdevices.com/showthread.php?t=117316