Re: volume control...

>Dean,
>
>To make it transmit codes for volume, you first need to set it up for a
>JVC receiver, then set it so the volume controls operate the receiver when
>in DVD mode. Like this
>
>S RCVR 0 1 8 ENT
>DVD
>S RCVR VOL+ ENT

Sounds good.

>Note the MAS3507D also has bass/treble controls...

It's on the list... :-)



>
>Regarding support for additional IR codes:
>
>It's unlikely because part of the IR decoding is currently done in the
>Xilinx - it's a rather bad design for legacy reasons (not using the right
>pins on the PIC for the right things, the first SliMP3 prototypes didn't
>have IR).
>
>Essentially the IR codes have to look "sorta like" JVC codes, WRT to the
>width of the pulses, and the measured part being the low part of the wave
>and not the high. There are several other codes that would have worked,
>except that they didn't implement all of the buttons on the rm-v301.
>
>We are going to have a custom remote eventually, so the plan is to support
>our own remote plus one or two standard IR codes so that people can use
>3rd party remotes if they want.

Sounds fine.  I might go remote shopping to find a more programmable 
one, in the mean time.

-dean

To unsubscribe from this group, send an email to:
[email protected]

 

Your use of Yahoo! Groups is subject to http://docs.yahoo.com/info/terms/