Re: DX7 Memory Corruption

"[email protected] [YamahaDX]" <[email protected]>
Newsgroups gmane.music.equipment.yamaha-dx
Message-ID <[email protected]> 
Where are you getting the 2uA figure from, Bruce?

The 1N4001-4009 series datasheet I've found only quotes 10uA at maximum reverse voltage, but that's 50V for a 1N4001.

Unfortunately, they don't give comparable figures, because they're meant for different purposes.  If you look at the figures for them getting hot, and near their reverse voltage limits, they're in the same ball park.

I couldn't find figures for the 1N4001 for a low reverse voltage.  It's probably a little bit higher than the 1N4148, but 2uA at 2-3V doesn't seem right.

- Andy
lmpx.com only provides a reader for public news (NNTP) servers. It is not affiliated with the servers or forums shown here and is not responsible for the content of articles, which is written by their respective authors.