Re: rasqlinsert - needs mysql header files

John Gerth via Argus-info <[email protected]>
Newsgroups gmane.network.argus
Organization Stanford University
Message-ID <32276_1460064549_u37LT8NE056935_5706D121.5060908@graphics.stanford.edu> 
The 'configure' script only configures argus mysql support if the mysql development packages
which contain the necessary header (.h) files are installed.  The package names to install
depend on which Linux distribution and version level you are using.


On 4/7/16 2:09 PM, Taran Stryker via Argus-info wrote:
> Hi Carter, I'm trying to use the rasqlinsert client, but when I run the ./configure the makefile for rasmysql doesn't generate and then when I run
> make install to build the other example clients that one is obviously skipped. I was wondering if there were any other steps that I needed to take in
> order to use rasqlinsert. 
> 
> -- 
> - Taran Stryker
lmpx.com only provides a reader for public news (NNTP) servers. It is not affiliated with the servers or forums shown here and is not responsible for the content of articles, which is written by their respective authors.