Does Cricket support 10G Interfaces.

Hi,

 

Does cricket support 10G Interfaces?

 

 

We have installed some new 10 Gigabit Ethernet Cards on Cisco 7600 and
GSR 12000 Routers. Cricket is polling and collection the data. The
traffic is at 3G. I am using genRtrConfig to create the config file. 

 

My problems are:

1.                   genRtrConfig set the value for rrd-max to 4.2G not
10G as it should.

rrd-max             = 4294967295

      rrd-max-octets   = 536870911

 

2.                   If I change rrd-max = 10000000000. cricket graph
still shows as "4295.0 MBits/s ethernetCsmacd"

 

 

 

Regards,

 

Naveen Baldeo

Senior Engineer

Network Growth

IP Services Engineering
<mailto:[email protected] <mailto:[email protected]> >

 

****DISCLAIMER****

This e-mail may contain confidential information.  If you are not the
intended recipient, please notify the sender immediately and delete this
e-mail from your system.  You must not disclose this e-mail to anyone
without express permission from the sender.  The contents of all e-mails
sent to and received from Optus may be scanned, stored, or disclosed to
others at Optus' discretion.

 

Optus has exercised care to avoid errors in the information contained in
this e-mail but does not warrant that the information is error or
omission free.  The information (including any pricing information)
contained in this e-mail is subject to change.  This e-mail is not a
quotation or proposal and no contractual obligations arise until you and
Optus sign a formal written contract or formal variation to your
existing contract.  

 

Any pricing contained in this e-mail is exclusive of GST unless
otherwise stated.

 

-------------------------------------------------------------------------
Take Surveys. Earn Cash. Influence the Future of IT
Join SourceForge.net's Techsay panel and you'll get the chance to share your
opinions on IT & business topics through brief surveys - and earn cash
http://www.techsay.com/default.php?page=join.php&p=sourceforge&CID=DEVDEV