Re: Sub Interfaces

Hi Marc!

I tried the snmpwalk to the subifs (Serial) and I got a value with no
problem, with the ifInDiscards and ifInErrors
OID. Do you know how can I configure it in the cricket to graph them in
the subifs?

Danilo Perdomo
Ingeniero de Operaciones NOC
VP Operaciones Técnicas
Inter Barquisimeto - MSO
Ext.: 5393
Tlf.: 58-251-3355393 
      58-251-9355393
Cel.: 58-414-5750938
www.inter.com.ve



Marc Powell escribió:
>   
>> -----Original Message-----
>> From: [email protected]
>>     
> [mailto:cricket-users-
>   
>> [email protected]] On Behalf Of Danilo Perdomo
>> Sent: Wednesday, February 06, 2008 3:27 PM
>> To: [email protected]
>> Subject: [cricket-users] Sub Interfaces
>>
>> Hi all,
>>
>> I'm new with cricket. I want to monitor de Discards packages on the
>> sub-interfaces of my Cisco 7200 router.
>> So far cricket is graphing the Discards (ifInDiscards) on the main
>> interface, but when i try the same config
>> with the sub-if I don't get any values.
>>     
>
> Are you sure the router is providing discard information for the
> subinterface type you're polling? My experience is that generally only
> Octets are reported for subifs. Have you tried an SNMP walk or querying
> the OID with snmpget to make sure it's valid?
>
> --
> Marc
>
>   
-------------------------------------------------------------------------
This SF.net email is sponsored by: Microsoft
Defy all challenges. Microsoft(R) Visual Studio 2008.
http://clk.atdmt.com/MRT/go/vse0120000070mrt/direct/01/