Re: dhcrelay prints these logs and doesn't live normally. [Can't initialize context: not enough free resources.]

hi pkd,

So you're saying this only happens sometimes and it is not predictable 
when it may or may not work?

Instead of "kill -9 <pid>" use "kill <pid>" where <pid> is replaced by 
the process id number. The default is usually -15 (Terminate)

regards,
Glenn

On 2021-05-31 15:59, 박기당 wrote:
> hi, Glenn.
> 
> How do I terminate to clean up without killi -9?
> It compiles dhcp-4.2.6 and operates on embedded target systems.
> dhcrelay is being restarted when the address of the interface
> associated with dhcrelay is added or deleted.
> And I've never seen such an error before, and it's not reproduced
> afterwards, so I don't know if it's meaningful to apply strace.
> I always kill dhcrelay and run it again two seconds later.
> 
> regards,
> 
> pkd.
> _______________________________________________
> ISC funds the development of this software with paid support
> subscriptions. Contact us at https://www.isc.org/contact/ for more
> information.
> 
> dhcp-users mailing list
> [email protected]
> https://lists.isc.org/mailman/listinfo/dhcp-users
_______________________________________________
ISC funds the development of this software with paid support subscriptions. Contact us at https://www.isc.org/contact/ for more information.

dhcp-users mailing list
[email protected]
https://lists.isc.org/mailman/listinfo/dhcp-users