reports failed but works
"Yuma Technical Inc." <[email protected]>
| Newsgroups | gmane.network.dhcp.isc.dhcp-server |
|---|---|
| Message-ID | <[email protected]> |
I am running a PXE service on buster. On a client it searches for a DHCP server, for about a minute. Meanwhile on the server "sudo systemctl status isc-dhcp-server.service” reports …Active: failed (Result: exit-code)… . Then I issue “sudo systemctl restart isc-dhcp-server.service” - reply:”Job for isc-dhcp-server.service failed because the control process exited with error code.…”. However back on the client, I restart and again it searches for a DHCP server. In a second or two it is assigned an IP … On the server, “sudo systemctl status isc-dhcp-server.service” tells me the PID. “journalctl _PID=1234” gives all the messages “… DHCPINFORM from x.y.z.xx via wlan0” and “… DHCPACK to x.y.z.xx (a:b:c:d:e:f) via wlan0” - over and over. Why does it report failed (with non-error responses) when it works? _______________________________________________ ISC funds the development of this software with paid support subscriptions. Contact us at https://www.isc.org/contact/ for more information. dhcp-users mailing list [email protected] https://lists.isc.org/mailman/listinfo/dhcp-users