Re: setting up a dnscurve forwarder

On Fri, Jul 31, 2009 at 8:56 AM, Faried Nawaz<[email protected]> wrote:
> I spent some time today setting up the DNSCurve forwarder for a domain.
> Here's what I did.

Thanks for writing this up! :)

> I used what's available right now: NaCl 20090405 and revision
> 488b8a21b8cd870b499436346534d3207216291e of mrd/dnscurve.  I set up the
> forwarder on a 64-bit Debian 5.0 system.  The forwarder uses epoll, so
> it won't compile on, say, FreeBSD.

Note that the forwarder also doesn't support TCP queries, so if you
need support for large response packets, you should probably hold off
until TCP support has been added.