Re: BIND doesn't listen to other loopback addresses
Greg Choules via bind-users <[email protected]>
| Newsgroups | gmane.network.dns.bind9.user |
|---|---|
| Message-ID | <CANsEUy1rrq0iLsqRQiwKCycARbkvTxffWmvhs=t_X21zVc372A__17653.3836683788$1751779851$gmane$org@mail.gmail.com> |
https://bind9.readthedocs.io/en/stable/reference.html#namedconf-statement-automatic-interface-scan Note the phrase "...and supported by the operating system...". Linux capabilities must also be enabled (i.e. not *disabled* at build time) for BIND to be able to keep scanning as addresses come and go and interfaces go up and down. This behaviour will be recorded in the log. Hope that helps. Cheers, Greg On Sun, 6 Jul 2025 at 06:21, Bagas Sanjaya <[email protected]> wrote: > On Sun, Jul 06, 2025 at 11:52:35AM +1000, Mark Andrews wrote: > > Listen-on is an acl. The interface table is scanned for matches which > are then bound to. This is documented behaviour. > > in ARM? > > -- > An old man doll... just what I always wanted! - Clara > -- > Visit https://lists.isc.org/mailman/listinfo/bind-users to unsubscribe > from this list > > ISC funds the development of this software with paid support > subscriptions. Contact us at https://www.isc.org/contact/ for more > information. > > > bind-users mailing list > [email protected] > https://lists.isc.org/mailman/listinfo/bind-users > -- Visit https://lists.isc.org/mailman/listinfo/bind-users to unsubscribe from this list ISC funds the development of this software with paid support subscriptions. Contact us at https://www.isc.org/contact/ for more information. bind-users mailing list [email protected] https://lists.isc.org/mailman/listinfo/bind-users