Re: BIND doesn't listen to other loopback addresses

On Sun, Jul 06, 2025 at 08:10:58PM +0200, Bjørn Mork via bind-users wrote:
> Bagas Sanjaya <[email protected]> writes:
> 
> > Here in my case, I was expecting BIND to listen to 127.0.0.53 as
> > separate address, just like in similar applications (systemd-resolved,
> > dnsdist, etc).
> 
> You do need to add the address to an interface, but you don't need to
> add a new dummy interface.  This will make your config work too:
> 
>  ip addr add 127.0.0.53 dev lo
> 
> It doesn't matter that lo already is configured with 127.0.0.1/8.  You
> can still add specific /32s within the same prefix.

That override won't persist across reboots, though, in my case (I'm using
NetworkManager).

Thanks.

-- 
An old man doll... just what I always wanted! - Clara

-- 
Visit https://lists.isc.org/mailman/listinfo/bind-users to unsubscribe from this list

ISC funds the development of this software with paid support subscriptions. Contact us at https://www.isc.org/contact/ for more information.


bind-users mailing list
[email protected]
https://lists.isc.org/mailman/listinfo/bind-users

-----BEGIN PGP SIGNATURE-----

iHUEABMIAB0WIQQJRmM4Nl+8BKPNGvtCNk3+7YYOdAUCaGsMvQAKCRBCNk3+7YYO
dPLfAP91rkVAxz4qMk+pV1wQXGy2OopiWAer6mplvum5FA5+kwD+J5PPo6RtEDza
iaGczERe9PYiUlemh/MiOOI6x0dET5k=
=7jOT
-----END PGP SIGNATURE-----