Re: BIND doesn't listen to other loopback addresses

Hi,

I do not know if you are using Redhat EL 9 or not but I found this
article from Redhat  that seems to describe how one might manage the
loopback interface with NetworkManager:
https://access.redhat.com/solutions/2108251

On Mon, Jul 7, 2025 at 4:48 AM Bagas Sanjaya <[email protected]> wrote:
>
> On Mon, Jul 07, 2025 at 03:28:57AM +0200, Michael De Roover wrote:
> > On Monday, July 7, 2025 1:54:41 AM CEST Bagas Sanjaya wrote:
> > > That override won't persist across reboots, though, in my case (I'm using
> > > NetworkManager).
> > >
> > > Thanks.
> >
> > ...
>
> That's not what I mean.
>
> As I iterate: I work around this problem by explicitly adding additional
> IP address to the loopback interface (see my initial post on this thread).
> Yet, the change **does not** persist on reboot (IOW, that 127.0.0.53 address
> is gone or back to defaults). Hence, I have to add dummy interface.
>
> Thanks.
>
> --
> An old man doll... just what I always wanted! - Clara
> --
> Visit https://lists.isc.org/mailman/listinfo/bind-users to unsubscribe from this list
>
> ISC funds the development of this software with paid support subscriptions. Contact us at https://www.isc.org/contact/ for more information.
>
>
> bind-users mailing list
> [email protected]
> https://lists.isc.org/mailman/listinfo/bind-users
-- 
Visit https://lists.isc.org/mailman/listinfo/bind-users to unsubscribe from this list

ISC funds the development of this software with paid support subscriptions. Contact us at https://www.isc.org/contact/ for more information.


bind-users mailing list
[email protected]
https://lists.isc.org/mailman/listinfo/bind-users