adding/removing slave zones

Hi there,

I have this setup, where I would like to add and remove a larger amount of slave zones rather regularly.

What I currently do is this:
I have a directory included in my nsd.conf.
I put a file with a 'zone:' definition per slave zone in there.
After I add or remove a zone, I use 'nsd-control reconfig' to reload NSD's configuration.

However, telling NSD to reload it's entire configuration feels a bit rough. Therefore I am curious about, if there are better ways to do this.

Best regards
Andreas

_______________________________________________
nsd-users mailing list
[email protected]
https://open.nlnetlabs.nl/mailman/listinfo/nsd-users