Re: Notice to Package SMEServer-5.6*.rpm

To : All upgraders

As I believe the reason for no Update RPM is the problems linked with mppe
architecture setup I have sat down and written a small "selector" routine.

Before one goes tearing off and bundling up Update5 I though I had better
check
if some kind soul had beaten me to it.

The format I have penciled in would have 2 directories "rpms and mppe" with
an installer
that would pick one of the 4. Based on the older 5.1.2Update3 by Darrell May

Regards

Stewart Evans
Network Technician
Lygon IT
[email protected]
(618) 8211 8522

----- Original Message ----- 
From: "Rob Wellesley" <[email protected]>
To: "SME Developers List" <[email protected]>
Sent: Monday, October 20, 2003 11:01 AM
Subject: [e-smith-devinfo] SMEServer-5.6*.rpm


> Hi there
>
> Finally got some time to start updating 5.6 server's with the OpenSSH and
> ProFTP updates and noticed no SMEServer-5.6Update*.rpm on the mirrors - is
> this right?
>
>
> Kind Regards
>
> Rob Wellesley
>
> Network Support Division
> Winux Limited
>
> Ph:  03 9817993
> Fax: 03 9800919
>
>
>
>
> --
> Please report bugs to [email protected]
> Please mail [email protected] (only) to discuss security issues
> Support for registered customers and partners to [email protected]
> To unsubscribe, e-mail: [email protected]
> For additional commands, e-mail: [email protected]
> Searchable archive at
http://www.mail-archive.com/devinfo%40lists.e-smith.org
>
>


--
Please report bugs to [email protected]
Please mail [email protected] (only) to discuss security issues
Support for registered customers and partners to [email protected]
To unsubscribe, e-mail: [email protected]
For additional commands, e-mail: [email protected]
Searchable archive at http://www.mail-archive.com/devinfo%40lists.e-smith.org