Re: ISCSI boot problem

Thanks , i have solve my problem :) you are right

2010/5/3 Kristof Van Doorsselaere <[email protected]>

> That depends on what's configured on your SAN (in your case the windows
> machine with starwind iscsi target software)
>
> If you created a target with alias win2003, it probably is something like
> this: *iqn*.2008-08.com.starwindsoftware:win2003
>
> Kristof
>
> On Mon, May 3, 2010 at 6:35 PM, Romain Van Vooren <
> [email protected]> wrote:
>
>> Thanks but what information should i put instead of exemple.com ?
>>
>> 2010/5/3 Kristof Van Doorsselaere <[email protected]>
>>
>>> it looks like you are specifying a faulty iscsi IQN
>>>
>>>  "iscsi:"<servername>":"<protocol>":"<port>":"<LUN>":"<targetname>
>>>
>>> targetname should be a valid iscsi IQN eg:
>>>
>>> *iqn*.*example.com*:disk1
>>>
>>> Kristof
>>>
>>> On 03 May 2010, at 17:13, Romain Van Vooren wrote:
>>>
>>> "sanboot iscsi:192.168.1.101::::win2003" what is wrong ???
>>>
>>>
>>>
>>>
>>> ------------------------------------------------------------------------------
>>>
>>> _______________________________________________
>>> Etherboot-discuss mailing list
>>> [email protected]
>>> https://lists.sourceforge.net/lists/listinfo/etherboot-discuss
>>>
>>>
>>
>

------------------------------------------------------------------------------

_______________________________________________
Etherboot-discuss mailing list
[email protected]
https://lists.sourceforge.net/lists/listinfo/etherboot-discuss