Re: What's the correct syntax of the "SNMP/MIB modules to load" separator?

Jaap Keuter <[email protected]> Fri, 28 Apr 2006 12:36:09 +0200 (CEST)

Newsgroups	gmane.network.ethereal.devel
Message-ID	<[email protected]>

Hi,

I've run into that a while ago and changed it so that the dissector
accepts them either way.

Thanx,
Jaap

On Fri, 28 Apr 2006, Ulf Lamping wrote:

> Hi List!
>
> I've just noticed that my Preference setting "Protocols/SNMP/MIB
> modules to load" is using ':' as the separator char for each MIB, while
> recent Ethereal versions seem to use ';'.
>
> Was this changed some time ago and what's the correct syntax now?
>
> Regards, ULFL