Re: SOLUTION : ethereal is not recognising any of pluggins (noentry in Enable Protocol)

hi all, i got soluton : 
just make a folder in my case 0.10.14 (i.e. version no.) in pluggins. copy all pluggins dll  there & it is ready.

raman
  ----- Original Message ----- 
  From: Raman Singla 
  To: Ethereal development 
  Sent: 2006 Jun 07 5:05 PM
  Subject: [Ethereal-dev] ethereal is not recognising any of pluggins (noentry in Enable Protocol)


  Hi all,
  i wrote an pluggins for decoding of gprs messages & i m able to generate a dll file for that pluggin too. But when i m running ethereal is not recognising this dissector & when i look in Enable Protocol list there is no entry for any of pluggins dissectors.

  I feel it is b'cos of Step no. 5 given in readme.pluggins.  Here is step 5 . 
  ----------------------------------------------------
  The bad news is that ethereal will not use the plugin unless the 

  plugin is installed in one of the places it expects to look.

  One way to deal with this problem is to set up a working root for 

  ethereal, say in $HOME/build/root and build ethereal to install

  there

  ./configure --prefix=${HOME}/build/root;make install

  then subsequent rebuilds/installs of your plugin can be accomplished 

  by going to the plugins/xxx directory and running 

  make install

  ------------------------------------------------

  Kindly let me know where i need to change/put all these dll's so that ethereal recognise these dissectors. 

  I m building this on Windows using 0.10.14. 



  Raman
  Ext - 1667



------------------------------------------------------------------------------


  _______________________________________________
  Ethereal-dev mailing list
  [email protected]
  http://www.ethereal.com/mailman/listinfo/ethereal-dev

_______________________________________________
Ethereal-dev mailing list
[email protected]
http://www.ethereal.com/mailman/listinfo/ethereal-dev