Re: Want to capture WLAN packets

Hi Madhur,

have a look at http://wiki.ethereal.com/CaptureSetup/WLAN for  
information on how to set your card to monitor mode. To get correct  
Assoctiation IDs, you could apply this patch: http://www.ethereal.com/ 
lists/ethereal-dev/200605/msg00225.html

Regards

Christoph

Am 13.06.2006 um 13:36 schrieb madhur:

> Hi All,
>
> I want to capture 802.11 WLAN packets from Ethereal. But when I  
> tried with NetGear wireless card, I was able to capture Ping packets
>
> But It was not showing any WLAN packets like
>
> 1)       Beacon frames
>
> 2)       Authentication request/response
>
> 3)       Association request/response
>
>
> So please any buddy can tell me how to capture these packets.
>
>
> Madhur
>
>
>
>  This e-mail and attachments contain confidential information from  
> HUAWEI, which is intended only for the person or entity whose  
> address is listed above. Any use of the information contained  
> herein in any way (including, but not limited to, total or partial  
> disclosure, reproduction, or dissemination) by persons other than  
> the intended recipient's) is prohibited. If you receive this e-mail  
> in error, please notify the sender by phone or email immediately  
> and delete it!
>
>
> _______________________________________________
> Ethereal-dev mailing list
> [email protected]
> http://www.ethereal.com/mailman/listinfo/ethereal-dev