Re: unable to connect after new installation of freenet on a fit-pc and ubuntu 8.04

On Tue, 3 Jan 2012 03:13:24 +0000 (UTC), user1 wrote:
> I am using ubuntu 8.04 and fit-pc will not let me upgrade to newer
> ubuntu version.

Are you referring to Freenet or Ubuntu? :p

>         I have reinstalled freenet with a bigger new datastore
>         It is supposed just to run as a freenet server
>         It has been running for a couple of years without problems
>         When i reboot it starts all right and I want to let it run 24 
> hours/day 
>         After maybe an hour is says "Unable to connect.... try again"

So it does work, for a little bit? :) The last few lines of your
freenet/wrapper.log file should be informative. My guess is you're
running out of memory -- so I bet there's a huge thread dump at the end
of that file, at the top of which there is a little line saying "out of
memory", or something. Perhaps increasing your datastore increased your
memory requirements too far. Try a smaller datastore size.

>         Then I have to restart and same repeats
>         At most I had 7 nodes connected for a very short period
>         
>         Hardware fit-PC 1.0:
>         CPU: AMD Geode LX800 500MHz     
>         Chipset: AMD CS5536
>         Display: Integrated Geode LX display controller up to
> 1920x1440 Memory: 256MB DDR 333MHz soldered on-board
>         Hard disk: 2.5” IDE 60GB
>         Ports:
>          2 x RJ45 Ethernet ports 100Mbps
>          2 x USB 2.0 HiSpeed 480Mbps
>          RJ11 RS-232 (cable available from CompuLab)
>          VGA DB15
>          Stereo line-out audio (headphones)
>          Stereo line-in audio / Mic

Cool machine. How much? :D
_______________________________________________
Support mailing list
[email protected]
http://news.gmane.org/gmane.network.freenet.support
Unsubscribe at http://emu.freenetproject.org/cgi-bin/mailman/listinfo/support
Or mailto:[email protected]?subject=unsubscribe