Re: unable to connect after new installation of freenet on a fit-pc and ubuntu 8.04
user1 <[email protected]>
| Newsgroups | gmane.network.freenet.support |
|---|---|
| Message-ID | <[email protected]> |
On Tue, 03 Jan 2012 04:41:11 +0000, user1 wrote: > On Mon, 02 Jan 2012 22:45:36 -0500, Dennis Nezic wrote: > >> >> So it does work, for a little bit? :) The last few lines of your >> freenet/wrapper.log file should be informative. My guess is you're >> running out of memory -- so I bet there's a huge thread dump at the end >> of that file, at the top of which there is a little line saying "out of >> memory", or something. Perhaps increasing your datastore increased your >> memory requirements too far. Try a smaller datastore size. > Does not show "out of memory" > But says: "Error JVM appears hung: Timed out waiting for signal from JVM > JVM did not exit on request > Unable to start JVM >> >>> Then I have to restart and same repeats At most I had 7 nodes >>> connected for a very short period >>> >>> Hardware fit-PC 1.0: >>> CPU: AMD Geode LX800 500MHz >>> Chipset: AMD CS5536 >>> Display: Integrated Geode LX display controller up to >>> 1920x1440 Memory: 256MB DDR 333MHz soldered on-board >>> Hard disk: 2.5” IDE 60GB >>> Ports: >>> 2 x RJ45 Ethernet ports 100Mbps >>> 2 x USB 2.0 HiSpeed 480Mbps >>> RJ11 RS-232 (cable available from CompuLab) VGA DB15 Stereo >>> line-out audio (headphones) >>> Stereo line-in audio / Mic I have now reduced the size of memory usage from 512mb to 256mb but still have the same problem ? _______________________________________________ Support mailing list [email protected] http://news.gmane.org/gmane.network.freenet.support Unsubscribe at http://emu.freenetproject.org/cgi-bin/mailman/listinfo/support Or mailto:[email protected]?subject=unsubscribe