Re: OOM on start-up
Signal 11 <[email protected]>
| Newsgroups | gmane.network.freenet.support |
|---|---|
| Message-ID | <[email protected]> |
thanks for the advice. > Just to clarify, your node works fine, until you try using the > KeepAlive plugin? Yes. > What did you set maxmemory to? I set it to 512MiB. > Somewhere in freenet's Stats pages is a table of the running threads. > Perhaps you can look for clues there, or post that table here? I took two thread dumps, one during high CPU load on start-up, the other in normal low load after that. wrapper.log: http://pastebin.com/iQ45jaGX I also saved thread usage from Config->status page, thread usage: http://pastebin.com/JG9fXLJm which showed lots of "Pooled thread awaiting work" during the high CPU load. high: Pooled thread awaiting work : 268 (84.0%) normal: Pooled thread awaiting work : 23 (30.3%) regards, s11 _______________________________________________ Support mailing list [email protected] http://news.gmane.org/gmane.network.freenet.support Unsubscribe at http://emu.freenetproject.org/cgi-bin/mailman/listinfo/support Or mailto:support-request-RdDMkVZAZeuJnvDnx1genB2eb7JE58TQ@public.gmane.org?subject=unsubscribe