Use of --start in the docs for 2.00 pre/snaps...

-----BEGIN PGP SIGNED MESSAGE-----


A user on IRC/#freeswan came in asking why ipsec auto --start didn't work 
in FreeS/WAN 1.99

I checked, and sure enough, it doesn't work at all.  It's not in the man 
page (which is good in this case)

[root@pos4-1130 root]# ipsec auto --start
ipsec auto: unknown option `--start'

The correct --option is of course --up, however some of the docs for 
1.99 show examples using --start as he pointed me to config.html

I check 2.00-pre6 and todays snapshot, and they say the same thing.  grep 
reports:

/freeswan-2.00-pre6/doc]: grep "\-\-start " *.html 
HowTo.html:<PRE>        ipsec manual --start <VAR>name</VAR>
HowTo.html:<PRE>    ipsec auto --start net-to-net</PRE>
HowTo.html:<PRE>    ipsec auto --start net-to-net</PRE>
adv_config.html:<PRE>        ipsec manual --start <VAR>name</VAR>
config.html:<PRE>    ipsec auto --start net-to-net</PRE>
config.html:<PRE>    ipsec auto --start net-to-net</PRE>

These need to be changed before 2.00 final... Claudia?



- --
Ken Bantoft                The Unoffical FreeS/WAN Site:
[email protected]            http://www.freeswan.ca
                           PGP Key: finger [email protected]
"It is dangerous to be right when the government is wrong."
                    		-- Voltaire

-----BEGIN PGP SIGNATURE-----
Version: 2.6.3ia
Charset: noconv

iQCVAwUBPlGtU1iWUusaxGxpAQGbTgP9ELNmrURuGWA3b3nIzG6pNMd+HH1nkTwx
Q3ARrd3GLcmk8M9WfQQKJYB3d3jAhzMEV6QEBB1h8pFRV0sWsStNesbKZWA4SzRc
PMYCXvGOaBmEq3wAmM13fdB9H+IdWFHGx5jShc4XlTkUvTS7M3ouqyHanuf86zgi
d8dLNOTwefg=
=AwW9
-----END PGP SIGNATURE-----