Re: ipsec can not start

-----BEGIN PGP SIGNED MESSAGE-----

On Fri, 14 Mar 2003, [gb2312] Фº£ÌÎ wrote:

> while i compole the ipsec.it can not started 
> version is freeswan-2.00-pre6-x509patch-1.1.5.tgz
> 
> error:
>   ipsec_setup: (/etc/ipsec.conf, line 9) we only support version 2 ipsec.conf files -- `' aborted
> 
> why?

Because you didn't read the upgrading.html document.

http://www.freeswan.ca/docs/freeswan-2.00-pre6/doc/upgrading.html

- ---
Most ipsec.confs will work fine

... so long as you paste this line, with no preceding whitespace , at the 
top of your config file:

    version 2
- ---

There are some other notes in there you should probably read too, since 
the defaults have changed.



- -- 
Ken Bantoft                The Unoffical FreeS/WAN Site:
[email protected]            http://www.freeswan.ca
                           PGP Key: finger [email protected]
Sendmail may be safely run set-user-id to root.                                                                        
	-- Eric Allman, "Sendmail Installation Guide

-----BEGIN PGP SIGNATURE-----
Version: 2.6.3ia
Charset: noconv

iQCVAwUBPnIijliWUusaxGxpAQEd4wP7BQ8LUKVq8w4BONgwtMHwL/lmon44AwlI
XacuK605VjOrZ//YlURqghaxUtL86zRTsUoB26CtqCmIg5gGZkpwnOChpSe1S6EI
TwJFE5/XnqbrbSfbfUPDVZX43i+aIKCriS1d0uNfu+RLG/TMHYkdzYcDEnrK0K6F
SzJfgZmqork=
=4kSP
-----END PGP SIGNATURE-----