Re: shutdown task not triggered on gnunet-arm -e

You should never add your own signal handler, GNUNET_PROGRAM_run() does 
that already, by adding your own you remove the GNUnet signal handler 
and thus break the shutdown logic.

-Christian

On 10/26/22 10:15, [email protected] wrote:
> When running the service with gnunet-arm -i svc, the function added with
> GNUNET_SCHEDULER_add_shutdown is not being run when issuing gnunet-arm -k
> svc
> 
> If I add a sigterm handler and do GNUNET_SCHEDULER_shutdown there, it
> hangs and I have to sigint (and it doesnt halt).
> 
> If I run the service directly (without gnunet-arm) the shutdown task
> gets triggered.
> 
> Is this expected behavior?
> 
> Is there a recommended way to add teardown code when using gnunet-arm?
> 
> I'm on 1567c9472b917a097cace08a7b08fc724e14f381
> 
> thanks,
> l