Re: shutdown task not triggered on gnunet-arm -e

Do you have code in a repo somewhere that we can try?

On 26.10.22 13:02, [email protected] wrote:
> Ok, I understand.
> 
> Sorry it was not clear:
> 
> my main issue was the function registered via
> GNUNET_SCHEDULE_add_shutdown not firing - even if the signal
> handler from gnunet is in place.
> 
> 
> On Wed, Oct 26, 2022 at 10:22:27AM +0200, Christian Grothoff wrote:
> > You should never add your own signal handler, GNUNET_PROGRAM_run() does that
> > already, by adding your own you remove the GNUnet signal handler and thus
> > break the shutdown logic.
> > 
> > -Christian
> > 
> > On 10/26/22 10:15, [email protected] wrote:
> > > When running the service with gnunet-arm -i svc, the function added with
> > > GNUNET_SCHEDULER_add_shutdown is not being run when issuing gnunet-arm -k
> > > svc
> > > 
> > > If I add a sigterm handler and do GNUNET_SCHEDULER_shutdown there, it
> > > hangs and I have to sigint (and it doesnt halt).
> > > 
> > > If I run the service directly (without gnunet-arm) the shutdown task
> > > gets triggered.
> > > 
> > > Is this expected behavior?
> > > 
> > > Is there a recommended way to add teardown code when using gnunet-arm?
> > > 
> > > I'm on 1567c9472b917a097cace08a7b08fc724e14f381
> > > 
> > > thanks,
> > > l
> >