Re: HI
Jun Yin <[email protected]> Mon, 23 Jan 2006 12:18:19 -0800
| Newsgroups | gmane.network.ipv6.general |
|---|---|
| Message-ID | <[email protected]> |
Hi,
now it seems the tspc works and tunnel was established, what's the next step?
I got the ipv6 routing table:
[root@localhost tspc]# route -A inet6
Kernel IPv6 routing table
Destination Next Hop
Flags Metric Ref Use Iface
::1/128 ::
U 0 7 1 lo
2001:5c0:8fff:ffff::22/128 2001:5c0:8fff:ffff::22
UC 0 3 1 tun
2001:5c0:8fff:ffff::23/128 ::
U 0 33 0 lo
3ffe:ffff:0:f101::5/128 ::
U 0 36 0 lo
3ffe:ffff:0:f101::/64 ::
UA 256 0 0 eth0
2000::/3 ::
U 1 0 0 tun
fe80::20e:a6ff:fe44:26aa/128 ::
U 0 1062 0 lo
fe80::240:f4ff:fe88:c397/128 ::
U 0 2 0 lo
fe80::/64 ::
UA 256 0 0 eth0
fe80::/64 ::
UA 256 0 0 eth1
fe80::/64 ::
UA 256 0 0 tun
ff00::/8 ::
UA 256 0 0 eth0
ff00::/8 ::
UA 256 0 0 eth1
ff00::/8 ::
UA 256 0 0 tun
::/0 ::
U 1 0 0 tun
::/0 ::
UDA 256 0 0 eth0
::/0 ::
UDA 256 0 0 eth1
and then I hope I can access some ipv6 sites by the ipv6 tunnel. I
tried http://www.sixxs.net/main/ and www.kame.net, but they alwasys
said I'm using ipv4 address. How can I force the traffic to use ipv6
tunnel? Do I need some special ipv6 dns setup?
Any response will be very appreciated.
--
Rgds,
Hans Yin
Email: [email protected]
MSN: [email protected]
Skype: hans_yin_vancouver
---------------------------------------------------------------------
The IPv6 Users Mailing List
Unsubscribe by sending "unsubscribe users" to [email protected]